隨著使用時間的不斷增長，濟南通風管道會積累大量雜質。這些雜質將在管道中儲存很長時間，并在運行過程中加速它的油冷凝。溫度轉換過高，會對氣壓閥、液壓等部件造成損壞，并對正常運行產生很大影響。因此，定期清理通風管道設備是非常必要的。如何清理?下面跟隨小編一起來看看吧
With the continuous growth of service time, Jinan ventilation duct will accumulate a lot of impurities. These impurities will be stored in the pipeline for a long time and accelerate its oil condensation during operation. If the temperature conversion is too high, it will damage the air pressure valve, hydraulic pressure and other components, and has a great impact on the normal operation. Therefore, it is necessary to clean the ventilation duct equipment regularly. How to clean up? Let's follow Xiaobian to have a look
(1)風管與風機連接時，應在進風口和出風口加裝軟接頭。軟接頭的橫截面尺寸應與風扇進氣口和排氣口的橫截面尺寸相同。軟管接頭可以由帆布、人造革和其他材料制成。軟管的長度不應小于200，并且松緊應適當。軟管可以緩沖風扇的振動。


(1) When the air duct is connected with the fan, the soft joint should be installed at the air inlet and outlet. The cross-sectional dimension of the flexible joint shall be the same as that of the fan inlet and outlet. Hose connections can be made of canvas, synthetic leather and other materials. The length of the hose should not be less than 200, and the tightness should be appropriate. The hose can cushion the vibration of the fan.
(2)風管連接除塵設備和加熱設備時，設備安裝完畢后，根據理論測繪圖暫停預制安裝。
(2) When the air duct is connected with the dust removal equipment and heating equipment, the prefabrication and installation shall be suspended according to the theoretical mapping map after the equipment is installed.
(3)濟南通風管道安裝時，風管預制時應打開進出口。如果安裝結束時風管需要打開，其接口應緊密。
(3) When Jinan ventilation duct is installed, the inlet and outlet should be opened when the air duct is prefabricated. If the air duct needs to be opened at the end of installation, its interface should be tight.
(4)輸送冷凝水或水分含量大的氣體時，其水平管道應設置坡度，并在低點與排水管連接。安裝時，風管底部不應出現縱向接縫，底部接縫應暫停密封處理。
(4) When transporting condensate water or gas with large moisture content, the horizontal pipeline should be set with slope and connected with drainage pipe at low point. During installation, there should be no longitudinal joint at the bottom of the air duct, and the sealing treatment of the bottom joint should be suspended.
(5)對于輸送易燃易爆氣體的鋼板風管，應在風管的連接法蘭處安裝跨接導線，并與靜電接地網連接。
(5) For the steel plate air duct conveying inflammable and explosive gases, the jumper wire should be installed at the connecting flange of the air duct and connected with the electrostatic grounding grid.
(6)當水平風道高度在4m以上時，裝置人員應系安全帶。腳手架或移動式支架上的跳板應固定好，跳板寬度應契合安全規范，在腳手架上的裝置人員宜攜東西袋，避免東西或電鉆等物掉落傷人。
(6) When the height of horizontal air duct is more than 4m, the installation personnel shall wear safety belt. The springboard on the scaffold or mobile support should be fixed, and the width of the springboard should conform to the safety regulations. The installation personnel on the scaffold should carry bags to avoid falling objects or electric drills to hurt people.
(7)雙吊桿支架在風道內就位后，橫臂應平直，吊桿不得改變，雙吊桿應受力均勻。
(7) After the double suspender bracket is in place in the air duct, the cross arm shall be straight, the suspender shall not be changed, and the double suspender shall be stressed evenly.
濟南通風管道
Jinan ventilation duct
濟南通風管道好每三個月清洗一次，這樣不僅可以保證平時正常運行，而且可以延長通風管道的使用壽命。
Jinan good ventilation pipe cleaning every three months, this can not only ensure normal operation, but also can extend the service life of the ventilation pipe. 上一篇：通風管道降溫需要注意哪些細節呢?
下一篇：山東通風管道的雜質該如何處理？